This article covers the Standard Procedure for rescuing a surface supplied diver. It also covers identifying a lost diver and performing CPR. Before diving rescues, it is best that you have the full certification. If you have a full certification, you will be able save the lives of others divers in an emergency. This article also covers the importance of finding the victim and performing CPR on the unconscious diver.
Standard procedure for salvaging a surface-supplied diver
Rescuers must immediately respond to any difficulty a surface-supplied diver may be experiencing and transport him or her safely to safety. This is typically a dive bell or an area where the diver cannot drown and first aid can be provided. There are instances when it is not possible to reach the diver via the bell. Rescue divers will need to adapt their response to the situation.
Secure the umbilicals first. The bell should be opened so that the umbilical is out of the bell. The surface tender should then follow a diver's umbilical from the bell. Depending upon the bell type, the diver could also be supplied by the individual umbilicals. To prevent snagging, divers' umbilicals must be secured.
The diver's tender, as well as the diving supervisor, should direct the rescuers. A standby diver might perform other tasks while a diver's life is saved. However, they must be able provide emergency help to the diver if necessary. It is crucial to ensure constant physical and audio contact with the diver while performing this procedure.
Recognizing a lost diver
It can be challenging to identify a lost diver. However, there are many methods that you can use to help find them. The first thing to do is contact the local authorities. In this instance, the diver was reported missing June 17th in Mukilteo Washington. Police and fire departments responded to this call. Coast Guard divers and sheriff's officers searched the area. They were unable to locate Korompis or his partner.
An alternative method to find a lost diver is using a MOB unit. This device sends out a distress message using an underwater radio frequency. However, the device only works if nearby vessels receive the signal. While it is recommended that you use this device, it may not be practical. Some boats lack AIS technology which makes it difficult for them to find a lost diver. SAR teams will still be able to assist the diver if there is an AIS signal on the vessel.
CPR on an inresponsive diver
CPR is an attempt to revive a diver if he or she stops breathing. By sliding your hand under the diver’s arm, or reaching up to hold his/her breathing equipment, you can open the airway. Next, gently pinch the nose of the diver and then roll him/her towards you. If the diver's breathing does not return, take two rescue breaths. Then, roll him or her towards you.
It is important to avoid trying to retrieve the bell of a diver during CPR. This could cause blood to pool. It is important to continue rescue breathing until the diver is able to regain consciousness. This could mean that the diver needs to be taken to a deck decompression chamber. Performing CPR on an unresponsive diver may be a complicated task, but it is necessary.
You can use buoyancy to bring the diver back to the surface if your pulse is visible. This will enable you to assess the condition of the diver, and determine if he requires rescue breaths. Alternating between rescue breaths, and 30 chest compressions, if the diver has stopped breathing, is possible. Alternate the breathing pattern for a maximum of 30 seconds.